Call-Point 发射机s - UHF

The 20-86 range of products can send text messages directly to paging receivers, providing simpler, lower cost systems since intermediate receivers and transmitters are not required for short range applications.

Using an appropriate receiver, 20-86-9000, can also be used for a general remote control applications such as turning on lights, disabling alarms etc.

Powered by a standard CR2032 coin cell, the transmitter will operate for more than one thousand transmissions under normal conditions before the battery needs to be replaced.

20-86 transmitters support up to five inputs, each of which can be programmed with up to a thirty five character message. The units can be programmed with a serial programming cable (purchased separately) or they can be supplied pre-programmed.

Although the 20-86 is a low power transmitter, when used as a call-point paging transmitter a direct line of sight range of up to eight hundred metres can be expected. When used within buildings the range will be reduced depending upon the building, but it will still be significant.

The 20-86-9000 fits the form factor of many standard electrical face plates so that it can remain in keeping with the surrounding switch gear in cosmetically sensitive areas.

By default 20-86-9000 is supplied with a mounting block, but it can be flush mounted in the same manner as most electrical switch plates if required. 

For configuration software please see the downloads tab.

• 超高频操作
• 体积小、重量轻 & 离散
• Internal cell battery
• 具有成本效益的
• Ideal for near distance paging, assistance, duress or operation of lights or doors etc.
• Capable of operating on existing in-house paging systems
• 1 or 2 button variants available, each button individually configurable with its own 35-character message
• Simple 遥测 solution or for use with pocket pagers
• Commercial paging solution